By film evaporator is mainly used in paint, beer, vegetable oil, medicine, chemicals, petroleum products, textile chemicals, photographic chemicals, plating solution, milk, mineral water, hot solvent, emulsion, industrial water, sugar, water, resin, printing ink, industrial waste water, fruit juice, edible oil, wax, etc.
Self-cleaning filter installation matters:
Install and use, should jacketed glass reactor pay attention to control box, sensors, and the protection of the transmission parts, prevent damage.
In the direction of the arrow tip self-cleaning filter on the ontology connection pipe, the flow direction in line with the arrow on the body side body.
Self-cleaning filters should be installed before the need to protect the water equipment, water and close to equipment.
In power system, self-cleaning filters should be installed between the pump and water equipment, the more close to the water equipment, the better. When the water pump and equipment before the pressure exceeds the cbd centrifugal extractor limit pressure of the filter, self-cleaning filter can also be installed in the pump before, and close to the pump.
The film evaporator operation steps are as follows:
1, enter the valve closed.
2, open the inlet valve.
Bag filter, introduced 3, gas, liquid pressure exhaust all left.
4, check the outlet pressure gauge, confirm hemp extraction centrifuge the gauge pressure with compressed air pressure is equal; Confirm there is no liquid flows out exports.
5, close the inlet valve.
6, slowly open the exhaust valve; Exports have residual liquid jet exhaust valve, it must be led to a safe place or suction mouth filter.
7, compressed air, after close the discharge valve. The filter inside should be no pressure, can open.